Shop
Brand
433MHz HC-12 Wireless Serial Port Module (1000m Range)
275,00 EGP- Compact, low-power 433MHz RF transceiver.
- Transparent TTL UART (serial) interface — plug & play.
- Long range: up to 1000 m line-of-sight (with suitable antenna).
- Configurable via AT commands (baud rate, channel, power, mode).
- Wide operating voltage for direct microcontroller connection.
- Low standby/operating current — suitable for battery systems.
- Reliable data link for telemetry, remote control, and sensor networks.
470 ohm 1/4 Watt (4pcs)
0,25 EGP- 🧰 Resistor set: 470Ω (1/4W) – 4 pieces
- ⚡ Power rating: 0.25W for general-purpose electronics
- 💡 Great for LED current limiting and indicator circuits
- 🧩 Useful for pull-up/pull-down and signal conditioning
- 🛠️ Through-hole type—easy breadboarding and soldering
- 📦 Pack of 4 pieces—handy for DIY and repairs
- 🔧 Common value for Arduino and prototyping projects
- ✅ Reliable resistors for everyday circuit building
470uF 35V Radial Electrolytic Capacitor
3,00 EGP- ⚡ 470µF radial electrolytic capacitor
- 🔋 Rated voltage: 35V for power filtering and smoothing
- 🧩 Ideal for DC power supplies, amplifiers, and motor circuits
- 🛠️ Through-hole radial leads for easy PCB soldering
- 📈 Helps reduce ripple, noise, and voltage dips
- 📦 Common value for repairs and electronics prototyping
- 🔧 Suitable for decoupling and bulk energy storage
- ✅ Great for Arduino and general electronics projects
47uF 50V Radial Electrolytic Capacitor
1,25 EGP- ⚡ 47µF radial electrolytic capacitor
- 🔋 Rated voltage: 50V for reliable power filtering
- 🧩 Ideal for smoothing, decoupling, and timing circuits
- 🛠️ Through-hole radial leads for easy PCB soldering
- 📈 Helps reduce ripple, noise, and voltage fluctuations
- 📦 Common value for repairs and prototyping
- 🔧 Suitable for power supplies, amplifiers, and control boards
- ✅ Great for general electronics and DIY projects
4A Single-Phase Diode Bridge Rectifier (1000V, Through-Hole)
9,00 EGP- 4A Current Rating: Suitable for moderate power AC to DC conversion
- Wide Voltage Range: Typically supports up to 1000V reverse voltage
- Full-Wave Rectification: Converts AC input to smooth DC output
- Compact & Reliable: Ideal for power supplies and DIY electronics
- Easy to Mount: Standard 4-pin configuration for simple PCB integration
4PIN IR Infrared Flame Detection Sensor Module
35,00 EGP✅ Compact 4-pin module with digital & analog output
✅ Adjustable sensitivity for varied flame sizes
✅ Compatible with Arduino, Raspberry Pi, and similar boards
✅ Fast and reliable flame detection
4WD Smart Robot Car Transparent Acrylic Chassis Kit
450,00 EGP- 🤖 4WD smart robot car chassis kit (transparent acrylic)
- ⚙️ 4-wheel drive design for better traction and stability
- 🧩 Plenty of mounting holes for Arduino, drivers, and sensors
- 🔋 Space for battery pack and control boards
- 🛠️ Easy assembly—great for beginners and STEM learning
- 🚗 Ideal for obstacle avoidance, line following, and RC robots
- 📦 Lightweight acrylic body with clean transparent look
- ✅ Perfect base for robotics experiments and competitions
5-Channel Flame Sensor Module
150,00 EGP- Detecting range: >120 degree
- Analog and digital outputs
- On-board potentiometer and indicators
- 1% resistors to make this module more reliable and precise
- Operating Voltage: 3.3V – 9V
- Board Diameter: 40 mm.
5-Pin Relay Holder Case Base for Breadboard (Unassembled)
30,00 EGPHigh RPM (~12000 at 5V) for dynamic mechanical tasks
500Ma Mini Solar Lipo Charger Board
100,00 EGP-
Based on CN3065 charge controller IC
-
Designed for single-cell LiPo battery charging
-
Solar panel input: 4.4V–6V
-
Max charging current: 500mA
-
Supports Micro-USB & solar input
-
JST-PH2.0 connectors for easy wiring
-
Battery status LEDs: Red (Charging), Green (Charged)
-
Built-in short circuit protection
-
Compact size, ideal for portable solar projects
-
Randomly shipped in HW-736 or equivalent version
560 ohm 1/4 Watt
0,25 EGP- Precision: Accurate 560 ohm resistance for stable circuit performance.
- Power Rating: 1/4 Watt, designed for low-power applications.
- Versatile: Perfect for DIY projects, audio systems, and general electronic circuits.
- Durable: High-quality build ensures long-lasting use in various electronics.
- Compact: Ideal for use on breadboards and in tight circuit designs.
